How Police Find Latent Fingerprints – Chemical Development – Part 3

Part 2 of this series discussed the use of latent print development powders. This article will cover some of the most popular chemical development methods.

Latent print powders are of little use on porous surfaces such as paper, cardboard and raw wood unless prints are known to be fresh; the reason being that a latent print is over 90% water, which is absorbed and dispersed in the surface. However, if prints are known to be fresh, regular black powder and magnetic powders may produce good results, and use of powders will not interfere with chemical processing. Crime scene investigators (CSIs) are able to recover latent prints from porous surfaces without a great deal of difficulty using chemical methods.

In Part 1 of this series you learned that a latent print is a combination of substances that make up human perspiration (sweat). The sweat pores exude substances like water, amino acid, carbohydrates, choline, proteins and uric acid. The fingertips also deposit oils from contact with areas of the body that harbor sebaceous glands-like on the face, arms and chest.

When examining porous objects like those listed above, the CSI or laboratory technician will follow a specific regimen of tests. Usually the first test is iodine fuming, which we will discuss in a subsequent lesson. Iodine fumes are used first as they are non-destructive to the testing that will follow. But iodine fumes are highly toxic and special care must be exercised when using iodine fuming techniques.

Special Note! All items that are transportable should be taken to the crime lab for processing.

Several chemical reagents are used in many crime labs as they are very sensitive and often produce spectacular results. Let’s take a look at the processing sequence recommended by the FBI and the British Home office. The best order of processing is: Iodine Fuming, DFO, Ninhydrin, and then either Silver Nitrate or Physical Developer. If Ninhydrin is used prior to DFO, the DFO prints will not fluoresce.

Note that DFO and Ninhydrin are a biological stains, and when they react with an amino acid, they exhibit a visible color. Amino acids are a component of sweat and oddly enough they do not disperse into the surface. In fact amino acids form a permanent bond with the cellulose structure of paper, cardboard and raw wood. And this bond conforms to the friction ridge structure of the finger depositing the print. flotation reagent

Special Note: Iodine Fuming will be covered in another article covering fuming methods like iodine and superglue.

DFO Treatment

DFO (1,8-Diazafluoren-9-One) is a Ninhydrin analog that reacts to amino acids, but it also has fluorescent properties. Here are the steps to treating a document with DFO: (Author’s Note! It is preferable to run these treatments in the crime lab since it is more efficient and much, much safer when a chemical fume hood [exhaust fan] is available!).

1. Place the object to be treated in a fume hood. In the case of a document, suspend it using evidence clips. Cardboard objects and pieces of wood may be placed on the floor of the fume hood. Be certain to treat all surfaces of each object, since you probably will not know just where latent prints may be found.


Leave a Reply

Your email address will not be published. Required fields are marked *